Get to know the new K3 high-speed non-contact infrared thermometer. You can use it in the office, subway, or supermarket. The approval rate per minute is greatly improved (50 people/min).
"Just bring your forehead about 5 centimeters away from the thermometer's sensor, and it will take your body temperature."
- Faster test time (500 ms); approval rate per minute is greatly improved
- High accuracy in temperature measurement, accuracy tolerance: +/- 0.2 degrees Celsius
- Can be connected to a USB power source, power bank, 18650 lithium battery (not included).
- Smart infrared forehead thermometer, no need to hold it, can be hung/fixed with double-sided tape/stand.
- Can be applied on different occasions. Office / Subway / Home / Supermarket / Store / Community / Entrance, etc.
| Accuracy | +/- 0.2 degrees | Response time | 0.5 Seconds |
| Automatic abnormal alarm | flashing + "Di Di" sound | Charging method | USB charging or battery (18650 Li-ion) |
| Automatic measurement: | measuring distance 5 cm ~ 10 cm | Input | USB DC 5V |
| Standby: | approximately one week | Weight: | 350g |
| Installation method: | nail hook, double-sided adhesive, bracket fixing | Dimensions: | 170 * 115 * 140 mm |
| Operating temperature | 10°C – 40°C (Recommended 15-35 °C) | Infrared measurement range | 0-50°C |
| Standby: | approximately one week | Display: | digital display |
BOTTOM VIEW
TOP VIEW
FRONT VIEW
REAR VIEW
OPERATION
Situation Description
Operation Instruction
1. Standby: The red dot at the bottom of the screen lights up in turn. (Figure 1)
2. Insufficient power: The horizontal bar lights up in the middle of the screen. (Figure 2)
3. Normal temperature: Green lights flash and a "Di" alarm sounds if it is above 37.5 degrees Celsius (Fig. 3)
4. Abnormal temperature: Red lights flash and a "Di Di" alarm sounds (Fig. 4)
5. Default:
"Lo": ultra-low temperature alarm. (Fig.5)
"HI": ultra-high temperature alarm (Fig. 6)
OPERATION INSTRUCTION
Temperature measurement: Forehead of the thermometer and bring it within 5-10 cm. (Fig. 7)
Mode change: there is a small hole on the back of the device (Fig. 8). You can use a 3mm diameter screwdriver
to insert the hole and then press the button.
(1) Temperature unit: press the 'mode switch hole' and then select 'C' or 'F' (Fig. 9, 10) C: Celsius F: Fahrenheit
(2) Mode: press and hold for 3 seconds and select 'b' 'Fig 11, 12'
AVAILABLE HERE AT PRO SALUD:
