Electrosurgery unit Valleylab Force FX Cat. VAL-FORCE-FX Valleylab

Valleylab Force FX Electrosurgical Unit Cat. VAL-FORCE-FX Valleylab

Description
The Valleylab Force FX Electrosurgical Unit for monopolar and bipolar surgery, cutting, and coagulation. Allows for highly professional surgery. It has audible and visual alarms, including the Patient Return Electrode Monitoring (REM) system. The REM detector is standard. It is available in cutting mode with a 300-watt output. It has a monopolar cutting foot pedal. With bipolar foot pedal.

Features:

• Cutting Modes: Provides flexibility through varying degrees of hemostasis. Choose one of three programmed modes.
• Independent Simultaneous Coagulation: Allows two surgeons to fulgurate or cut from one generator, adding convenience and efficiency. Accessories are activated only by means of a key, thus reducing the potential for injury caused by inadvertent activation.
• Low-Voltage Coagulation: Safely and precisely ensures electrosurgical desiccation with less peripheral tissue destruction, making the Force FX generator ideal for laparoscopic procedures.
• REM Safety: Guaranteed with the patented REM system. Adaptive Patient Return Electrode Monitoring, which continuously monitors patient impedance levels. If a fault in the patient return electrode contact is detected, the system deactivates the generator, virtually eliminating the risk of burns. The Valleylab REM safety system has been proven in more than 10 million surgical procedures worldwide.

Weight and Dimensions Specifications:

• HEIGHT: 20 CM.
• WIDTH: 33 CM.
• LENGTH: 53 CM.
• WEIGHT: 10.4 KILOGRAMS

CUTTING WAVEFORMS

• Cut: 510 kHz sine wave
• Mixed 1: 510 kHz sine wave bursts at 50% duty cycle. Recurring at 31 kHz.
• Mixed 2: 510 kHz sine wave bursts at 37.5% duty cycle recurring at 31 kHz
• Mixed 3: 510 kHz sine wave bursts at 25% duty cycle recurring at 31 kHz.
• COAG: 510 sine bursts with a recurring frequency of 31 kHz low voltage 510 kHz sine wave bursts at 25%.
• COAG: Recurring cycle at 31 kHz.
• Bipolar: 510 kHz sine wave. Power output changes by less than 5% or 5 watts, whichever is greater, while line voltage fluctuates between 85 - 135 volts) across a 300 ohm load.)

Low frequency leakage (50 - 60 Hz). All electrodes to ground

• Normal polarity: chassis intact ground < 10 µA
• Normal polarity: open ground <100 µA
• Reverse polarity: Open ground <100 µA
• Current sink, 140 volts applied, all power <150 µA

High frequency leakage

• Less than 150 mA rms.

Power requirements

• The operating range is 85 to 135 AC Volts. Current is less than 8 amperes in cut and less than 4 amperes in Coagulation.

Adaptive REM system

• Frequency measurement: 140 kHz ± 20 kHz.
• Current measurement: 3 mA maximum.

Natural convection cooling, not forced.
Audio volume

• The mode indicator tone is adjustable to a minimum level of 45 dB at one meter.
• Alarm tones are not adjustable and are set at a minimum of 65 dB at 1 meter.
• Also available in 220 to 240 volt, 50 - 60 Hz configuration.
• Designed to comply with UL and CSA specifications.